Allied Telesis SwitchBlade x3100 Series Manual page 135

CFC Media (SD Card)
RENAME FILE TO
Syntax
RENAME FILE={ sourcefile | unit:sourcefile } TO={ destinationfile |
unit:destinationfile }
Renames the specified file on the CFC flash file system. The file must already exist on the
Description
CFC flash file system. The command is disallowed if the specified file is already designated
as a preferred, alternate or temporary load file for a provisioned card. For a duplex sys-
tem, the operation is performed on both CFCs when they are both ONLINE. The
RENAME FILE command can also be used to rename the specified file on a specified
media card by prepending the name of the media card to the respective filenames. Exam-
ple: RENAME cflash9:myOldFilName TO cflash9:myNewFileName
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
FILE
TO
Example
RENAME FILE SD4:D104_14.1.0_19JULY.CFG TO
SD4:D104_14.1.0_OLD.CFG
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Description
The name of the file that is being copied from. The unit
is the SD card and the number of the CFC slot.
The name of the file that the file is being copied to. If
only the filename is specified, the file is copied to FLASH
memory. Note - In release 14.1 only one SD unit is
allowed on the active CFC, and so you cannot copy a file
from one SD unit to another.
Introduction
Default Value
1-105