Example Log Configuration Setup - Allied Telesis SwitchBlade x3100 Series Manual

Example Log Configuration Setup

SBx31CFC
CFC control module (console port)
1.11.4 Example Log Configuration Setup
An example sequence of setting up a log management system would be as follows:
Create a log filter - Use the
•
logs, called the filterid, and set up a criteria so logs that meet that criteria are collected together and associ-
ated with that filterid.
Create a log output - Use the
•
destination for the logs (called an outputid), set up the attributes for that destination (such as an IP address),
and specify the log format.
Associate the filterid with the outputid - Use the
•
associate the filterid with the outputid so that logs filtered in a certain way are sent to a certain destination.
The log format can be set to FULL, SUMMARY, or MSGONLY by using the FORMAT keyword with the
or the
LOG OUTPUT SET LOG OUTPUT
MARY format displays only the category, timestamp, and log type. The MSGONLY format displays only the log
message. A comparison of the formats is shown in
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
SBx3112
SBx3100
All logs (all Categories and Severities)
Physical Link
Critical Severity only
Categories CARD, SHLF only
Example Log Configuration
FIGURE 1-8
CREATE LOG FILTER=<filter name>
CREATE LOG OUTPUT=<output name>
command. The FULL format displays the entire log message. The SUM-
Figure
command to create a name for a set of
command to create a name for the
ADD FILTER OUTPUT=<output name>
1-9.
Introduction
outputids for:
SYSLOG server
TELNET/CLI
local
terminal
command to
CREATE
1-161