Configuration Procedure - Allied Telesis SwitchBlade x3100 Series Manual

Logging Procedures
1.11.6 Logging Procedures

1.11.6.1 Configuration Procedure

The following procedure shows the commands used in the configuration.
TABLE 1-30
Step Command
Show logs that match a criteria. For example, to view logs that have a severity level of CRITICAL, input the following:
officer SEC> SHOW LOG SEVERITY=CRITICAL
1.
*C SYS010 2010-04-16 14:39:42 3538 FAULT
System: Cleared Port Outage Threshold
Create a log filter for critical severity only
CREATE LOG FILTER=CRITICAL_log SEVERITY=CRITICAL
2.
Create a log output to associate with the log filterid CRITICAL
CREATE LOG OUTPUT=terminal DESTINATION=CLI FOR-
3
MAT=SUMMARY
Add the log filter created in step
ADD LOG FILTER=CRITICAL_log OUTPUT=TERMINAL
4.
Enable the output.
ENABLE LOG OUTPUT=TERMINAL
5.
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Configuration Procedure for LOG Filtering
2. to the log output created in step 3
Introduction
Description
1-163