Configuring VLAN Translation
There is a one-to-one mapping between the customer VLAN ID and the VLAN ID used for crossing the net-
•
work operator network. (Each customer VLAN ID can be translated into only one VLAN ID, and vice
versa.)
The customer VLANs to be translated must be tagged.
•
4.10.5.3 Configuration Procedure
The following procedure shows the commands used to provision and deprovision VLAN translations based on
Figure
4-27.
TABLE 4-32
Step
Command
Configure System A
CREATE VLAN=VLAN100 VID=100
1
CREATE VLAN=VLAN200 VID=200
Add interfaces to the VLANs
ADD VLAN=100 INTERFACE=0.1,0.2,2.0
2
FRAME=TAGGED
ADD VLAN=200 INTERFACE=0.1,0.2,2.1
3
FRAME=TAGGED
Set the translation option on interface 2.0
SET VLAN=100 INTERFACE=2.0 TRANS-
4
LATE=10
Set the translation option on interface 2.1
SET VLAN=200 INTERFACE=2.1 TRANSLATE=10
5
Configure System E
Create the VLANs
CREATE VLAN=VLAN100 VID=100
6
CREATE VLAN=VLAN200 VID=200
Add interfaces to the VLANs
ADD VLAN=100 INTERFACE=0.0,3.0
7
FRAME=TAGGED
ADD VLAN=200 INTERFACE=0.0,3.1
8
FRAME=TAGGED
Set the translation option on interface 3.0
SET VLAN=100 INTERFACE=3.0 TRANS-
9
LATE=10
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Configuration procedure for VLAN Translation
Description
Translate the Customer A VLAN ID 10 to
s
100.
Translate the Customer B VLAN ID 10 to 200.
Translate the Customer A VLAN ID 10 to 100
Introduction
4-209