Allied Telesis SwitchBlade x3100 Series Manual page 679

Configuring Port Authentication
SET DOT1X
Syntax
SET DOT1X [ACCOUNTING={STARTSTOP|STOP|NONE}]
This command is used to set the ACCOUNTING parameter for the 802.1X-based Port
Description
Authentication.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
ACCOUNT-
ING
Example
SET DOT1X ACCOUNTING=STARTSTOP
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Description
STARTSTOP - The switch sends start packets when a
supplicant successfully authenticates, and stop packets
when a supplicant logs off.
STOP - The switch sends stop packets only.
NONE - No accounting packets are sent.
Introduction
Default Value
NONE
6-119