Create Snmp Community (Sec) - Allied Telesis SwitchBlade x3100 Series Manual

Configuring an SNMP Community

CREATE SNMP COMMUNITY (SEC)

Syntax
CREATE SNMP COMMUNITY=name [ACCESS={READ|WRITE}] [V2CTRAPHOST=ipad-
dress-list] [TRAPHOST=ipaddress-list] [MANAGER=ipaddress-list]
The CREATE SNMP COMMUNITY command creates an SNMP community. Optionally,
Description
the command sets the access mode for the community and defines a trap host and man-
ager. Trap hosts and managers are also added through the ADD SNMP COMMUNITY
command. By default, the community is disabled and must be enabled to allow access to
the SBx3112. (See
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
COMMU-
NITY
ACCESS
TRAPHOST
V2CTRAP-
HOST
MANAGER
Example
CREATE SNMP COMMUNITY=system_test V2CTRAPHOST=10.52.65.37
TRAPHOST=10.52.65.37 MANAGER=10.52.65.37
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
ENABLE SNMP COMMUNITY
Description
name - the name of the SNMP community; a case-sensi-
tive alphanumeric string of 1 to 15 characters.
The access setting for the SNMP community.
READ - allows read-only access
WRITE - allows read and write access
ipaddress-list - the list of IP addresses of the trap hosts,
separated by commas; the hosts to which traps are sent
ipaddress-list - the list of IP addresses of the SNMPv2c
trap host(s), separated by commas.
ipaddress-list - the IP address of the management sta-
tion(s) for this SNMP community. The management sta-
tion is a device from which SNMP requests with the
community name are deemed to be authentic. A com-
munity may have more than one management station.
(SEC)).
Default Value
READ
Introduction
7-57