IGMP Counters
PIMV2
Info (010017): Operation Successful
Information can be displayed about IGMP joins, leaves, and events, etc. using the SHOW IGMPSNOOPING
TRACE command.
The ENABLE TRACE command is used to enable logging of defined traces. Once traces are added and
Note:
enabled, when call events occur that match the criteria, a trace log is created and stored in the trace
log buffer. The SHOW TRACE BUFFER command is used to display the logs in the buffer, and the
CLEAR TRACE command is used to clear the buffer. See the User Event Logging section (8.8) for more
details.
8.7 EPSR Trace
The SBx3112 provides the user with the ability to display, in real time, the following EPSR events.
Hello packet generation
•
Hello packet reception
•
Failover Time Expiry
•
Failover Time Reset
•
LINK_UP/LINK_DOWN message generation
•
LINK_UP/LINK_DOWN message reception
•
RING_DOWN Flush generation
•
RING_DOWN Flush reception and corresponding flush action
•
RING_UP Flush generation
•
RING_UP Flush reception and corresponding flush action
•
Secondary port unblocking
•
Port into pre forwarding state
•
Refer to
Log Management
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
0
0
for information on setting output filters.
EPSR Trace
8-27