Allied Telesis SwitchBlade x3100 Series Manual page 806

Introduction
SHOW SNMP COMMUNITY (SEC)
Syntax
SHOW SNMP COMMUNITY [ ={ name-list | ALL } ]
The SHOW SNMP COMMUNITY command displays information about a single SNMP
Description
community. The COMMUNITY parameter specifies the name of the community. A com-
munity with the specified name must already exist in the device. The following is example
output from the SHOW SNMP COMMUNITY command:
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
SHOW SNMP COMMUNITY
SNMP community information:
Name .......................... public
Access ........................ read-only
Status ........................ Enabled
Traps ......................... Enabled
Open access ................... Yes
Manager ....................... 192.168.1.1
Manager ....................... 192.168.5.3
Trap host ..................... 192.168.1.1
Trap host ..................... 192.168.6.23 v2c
Traphost ...................... 192.168.6.24
7-68
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Option Description
COMMU- name-list - the name of the SNMP community; a case-
NITY sensitive alphanumeric string of 1 to 15 characters.
ALL - all SNMP communities on the system
Configuring an SNMP Community
Default Value