Configuring Vlan Translation - Allied Telesis SwitchBlade x3100 Series Manual

Introduction
The GE24POE, GE24SFP, and XE4 cards support both translated and non-translated VLANs on the
Note:
same port, which may be undesirable. Users should be careful in their network design to take this into
account.
The following table shows the support for HVLAN and VLAN Translations for each SBx3112 card:
TABLE 4-31
Feature
a
Extreme HVLANs
Can act as an HVLAN network port (Can be tagged HVLAN member)
Can act as an HVLAN customer port (Can be untagged HVLAN member)
Can support both tagged and untagged HVLANs (Can co-exist)
VLANTUNNEL HVLANS
VLAN Translation support
VLAN Translation Limit per Port
a. Requires hardware support for replacing packet TPID on egress

4.10.5 Configuring VLAN Translation

This section describes configuration information, procedures, and commands for the VLAN Translation.
4.10.5.1 Default Configuration
When an SBx3112 switch is initially booted up, VLAN Translation will be configured as follows:
There is no VLAN translation on any interface.
•
4.10.5.2 Configuration Guidelines
To configure the VLAN translation option, the following rules apply:
Refer to Table 4-31
•
4-208
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
HVLAN and VLAN Translation Support for the SBx3112
for cards support which translation functions
Configuring VLAN Translation
GE24POE GE24SFP
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
16 16
XE4
Y
Y
Y
Y
Y
Y
2048