Allied Telesis SwitchBlade x3100 Series Manual page 413

Configuring BPDU Cop
TABLE 4-15
Step Command
Ensure that (R)STP is enabled. Note that 0.23 is not included in the interface set.
SHOW STP
1
--- STP Information -----------------------------------------------------
Spanning Tree Type...................... RSTP
Instance Name......................... MAIN (0)
Instance State........................ ENABLED
............................................................
Int
----- ---------- ---------- ---------- ----------- ----------------
0.0 ROOT
0.22 ALTERNATE
1.2 DESIGNATED FORWARDING
1.3 DESIGNATED FORWARDING
11.23 DESIGNATED FORWARDING
Enable BPSU Cop for the 0.23 interface
SET STP INTERFACE=0.23 BPDUCOP=ON
2
Enable STP for the 0.23 interface
ENABLE STP INTERFACE=0.23
3
Info (040409): Spanning Tree Protocol operation is now enabled for the
Review the status of the interface
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Configuration Procedure for BPDU Cop
Role State
FORWARDING
DISCARDING
specified interface/interface-list (0.23)
Description (Optional)
Cost Prio.Number
20000 128.321
20000 128.343
2000 128.387
2000 128.388
200000 128.1048
Introduction
Type
RSTP
RSTP
RSTP
RSTP
RSTP
4-93