Allied Telesis SwitchBlade x3100 Series Manual page 802

Introduction
ENABLE SNMP AUTHENTICATE_TRAP (SEC)
Syntax
ENABLE SNMP AUTHENTICATE_TRAP
The ENABLE SNMP AUTHENTICATE_TRAP command enables the generation of
Description
authentication failure traps by the SNMP agent whenever an SNMP authentication failure
occurs. By default, authentication failure traps are disabled. When enabled, the following
conditions cause the generation of authentication failure traps:
- Invalid community used to access the device.
- Invalid use of community (Attempting a SET with a READ-ONLY community.
- Invalid access from a MANAGER which is not a "trusted" host or not associated with
the community associated with the SNMP operation. An authentication failure trap is not
generated if the community is set with OPEN=true. (See CREATE SNMP COMMUNITY
or SET SNMP COMMUNITY).
N/A
Options
Example
ENABLE SNMP AUTHENTICATE_TRAP
7-64
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Configuring an SNMP Community