Allied Telesis SwitchBlade x3100 Series Manual page 639

Configuring a TACACS+ Server
TABLE 6-17
Step Command
Set authentication mode to Command
SET TACPLUS AUTHMODE COMMAND
5
Change timeout value and number of retries
SET TAC SERVER 10.10.10.20 RETRIES 5 TIMEOUT 10
6
Verify the new settings for authentication mode, timeout value and number of retries
SHOW TACPLUS
7
--- TACACS+ -------------------------------------------------------------------
Auth Mode............................. Command
-------------------------------------------------------------------------------
--- TACACS+ Servers -----------------------------------------------------------
Hostname/IP Address Status
------------------- -------- ---- ----- ----- ------- ------- ----------------
10.10.10.20
Disable the TACACS+ server
DISABLE TACPLUS SERVER=10.10.10.20
8
Verify that TACACS+ server has been disabled
SHOW TACPLUS
9
--- TACACS+ -------------------------------------------------------------------
Auth Mode............................. Command
-------------------------------------------------------------------------------
--- TACACS+ Servers -----------------------------------------------------------
Hostname/IP Address Status
------------------- -------- ---- ----- ----- ------- ------- ----------------
10.10.10.20
Delete the TACACS+ server
DELETE TACPLUS SERVER 10.10.10.20
10
Verify that TACACS+ server has been deleted
SHOW TACPLUS
11
--- TACACS+ -------------------------------------------------------------------
No TACAC+ servers configured.
-------------------------------------------------------------------------------
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Configuration Procedure for TACACS+
Acct
Pri Port Port
Enabled 1 49 1813
Acct
Pri Port Port
Disabled 1 49 1813
Description
Retries Timeout Function
5 10 AUTHENTICATION
Retries Timeout Function
5 10 AUTHENTICATION
Introduction
6-79