Allied Telesis SwitchBlade x3100 Series Manual page 626

Introduction
SET EGRESSLIMITER
Syntax
SET EGRESSLIMITER=limitername [ RATE=bits-per-second ] [ BURST-
SIZE={ 4KB | 8KB | 16KB | 32KB | 64KB | 128KB | 256KB | 512KB | 1MB
| 2MB | 4MB | 8MB | 16MB | 32MB | 64MB } ]
Modifies an existing EGRESSLIMITER. This changes the limit on all ports/interfaces with
Description
which the EGRESSLIMITER is associated. See CREATE EGRESSLIMITER for a description
of the use of EGRESSLIMITERs.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
SET EGRESSLIMITER=sub_gold RATE=1M BURSTSIZE=256KB
6-66
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Option Description
EGRESSLIM- The name of the EGRESSLIMITER that has already been
ITER created.
RATE Specifies the rate to which transmitted traffic must be
limited (in bits per second). The rate may exceed this
value for up to the specified BURSTSIZE for a brief time.
The value must be a non-zero multiple of 8K bits-per-
second. The value may have a suffix of "K" (meaning
times 1,000) or "M" (meaning times 1,000,000).
BURSTSIZE Specifies the maximum size burst of traffic that is
allowed to exceed the specified RATE. The value is
entered from among an enumerated list of allowable val-
ues.
Configuring the Egress Port Rate Limiting
Default Value