Delete Lldp Interface Options - Allied Telesis SwitchBlade x3100 Series Manual

Introduction

DELETE LLDP INTERFACE OPTIONS

Syntax
DELETE LLDP INTERFACE={ type:id-range | id-range | ifname-list |
ALL }
OPTIONS
[ PORTDESC ] [ SYSNAME ] [ SYSDESC ] [ SYSCAP ] [ PORTVLAN ] [ VLAN-
NAME ] [ PROTOVLAN ] [ PROTOCOL ] [ MACPHYCONFIGSTATUS ] [ POWERVI-
AMDI ] [ LINKAGGREGATION ] [ MAXFRAMESIZE ] [ EPSR ] [ UCP ] [ ALL ]
Deletes one or more OPTIONS to the Interface(s) for LLDP. Note that this command
Description
does not disable LDP (that is the SET LLDP INTERFACE MODE command), but deletes
specified OPTIONS.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
DELETE LLDP INTERFACE=0.0, 3.22 OPTIONS=UCP
SHOW LLDP INTERFACE=0.0
--- LLDP Information ---
Interface.......................... 0.0
Mode............................... Off
SNMP Notifications................. Disabled
TLVs Enabled for Transmit.......... None
Local Interface Data
Port ID......................... Interface Name:
Port Description................ ETH:0.1
7-84
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Option Description
INTERFACE A logical representation of one or more physical ports;
the INTERFACE for which RMON data is enabled
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - used to specify the same historical data collection
parameters on all applicable interfaces in the system
OPTIONS Refer to Table 7-11.
ETH:0.1
Configuring LLDP
Default Value