Allied Telesis SwitchBlade x3100 Series Manual page 559

Configuring IGMP
SHOW TRACE IGMPSNOOPING
Syntax
SHOW TRACE IGMPSNOOPING [ MESSAGETYPE={ REPORTV1 | REPORTV2 | LEAVE
| GENERALQUERY | LASTMEMBERQUERY | ALL } ] [ INTERFACE={ type:id-
range | id-range | ifname-list | ALL } ] [ MACADDRESS={ macaddress
| ALL } ] [ GROUPADDRESS={ ipaddress | ALL } ]
This shows the status of what's been enabled for tracing, not the actual trace buffer
Description
(which is displayed using SHOW TRACE BUFFER).
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
IGMPS-
NOOPING
MESSAGE-
TYPE
INTERFACE
MACAD-
DRESS
GROUPAD-
DRESS
Example
SHOW TRACE IGMPSNOOPING
--- IGMP Packet Traces -------------------------------------------------------
Message Type
----------------- --------------- ----------------- --------------------------
ALL
ALL
-------------------------------------------------------------------------------
Software Reference for SwitchBlade x3100 Series Switches (Internet Group Management Pro-
tocol (IGMP))
Description
Select which category of IGMP snooping for the trace
The specific IGMP message type
ALL - All message types
The interface(s) from which to show the trace
A device's source MAC address.
The IP address of the multicast group
ALL - All IP addresses of the multicast groups
MC Group Source MAC
Address Address
ALL ALL
ALL 00:02:02:00:BC:80
Introduction
Default Value
ALL
Interface(s)
ETH:[0.22]
ALL
5-27