Allied Telesis SwitchBlade x3100 Series Manual page 856

Introduction
SHOW IP ROUTE
Syntax
SHOW IP ROUTE[={ipaddress-list|ALL}]
Lists the routing table data, which could have been obtained from static routing data
Description
(manually entered) or dynamic routing data (using routing protocols such as OSPF or
RIP).
When the command is entered with no values, the output is the routing table for all
interfaces, and does not include routing metrics. Each row displays the next hop to use
for the destination IP, type of routing, the routing protocol, the mask, and the age. In gen-
eral, a route is chosen based on the row whose ageing timer has not expired (non-dirty)
and has the largest match with the destination IP address. When a route is chosen the
packet is forwarded to the next hop router entry in the row. If no match is found, the
packet is forwarded to a default router
When the command includes an IP address, the specific row is listed, and includes the
routing metrics.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
E134 - officer SEC>>>> show ip route
--- IP Routing Table -----------------------------------------------------
Intf Dest Id
Id
---- -------------- --------------- ----- ------ ------------------- ----
2 0.0.0.0
2 10.52.71.0
1 127.0.0.1
--------------------------------------------------------------------------
7-118
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Option Description
ROUTE ipaddress-list - a comma delimited list of ip
addresses.
ALL - All IP addresses
Next Hop
10.52.71.1
10.52.71.84
127.0.0.1
Access of MIB Statistics Using an SNMP Browser
Type Proto Mask
4 1 255.255.255.255
3 2 255.255.255.255
3 2 255.255.255.255
Default Value
ALL
Age
7245
7245
7254