Show Dot1X Interface - Allied Telesis SwitchBlade x3100 Series Manual

Configuring Port Authentication

SHOW DOT1X INTERFACE

Syntax
SHOW DOT1X [INTERFACE={type:id-range|id-range|ifname-list|ALL}]
[FULL]
This command is used to display per-interface settings for 802.1X-based Port Authentica-
Description
tion.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
FULL
Example
SHOW DOT1X INTERFACE=6.22-6.23
--- Port Authentication Interface ---
Interface Status
--------- ------------- ------------
ETH:6.22 Enabled
ETH:6.23 Enabled
sh dot1x interface 6.22
--- Port Authentication Interface ---
Interface............................. ETH:6.22
802.1X Authentication Status.......... Enabled
PortControl........................... Auto
ReauthEnabled......................... OFF
ReauthPeriod.......................... 3600
QuietPeriod........................... 60
ServerTimeout......................... 30
SupplicantTimeout..................... 30
ControlDirection...................... Both
EAPOLVersion.......................... 2
ReauthMax............................. 2
TxPeriod.............................. 30
EAPReqMax............................. 2
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Description
The ethernet interfaces over which the DOT1X
attributes will be shown.
Displays more descriptive information
PortControl
Auto
Auto
Introduction
Default Value
ALL
Abbreviated
unless only one
interface is shown.
6-131