Create Stp Instance Mstid - Allied Telesis SwitchBlade x3100 Series Manual

Configuring BPDU Cop

CREATE STP INSTANCE MSTID

Syntax
CREATE STP INSTANCE=stpname MSTID=1..4094 [ PRIORITY=0..65535 ]
For MSTP, create an STP instance and give it a name as well as ID. VLANs can then be
Description
associated with this instance.
The following table gives the range of values for each option that can be specified with
Options
this command and a Default Value (if applicable).
Option
INSTANCE
MSTID
PRIORITY
Example
(Create mstp instance mstd9, mstp and region already set)
officer SEC>> create stp instance mst9 mstid 9
Info (010017): Operation Successful
show stp
--- MSTP Configuration Identifier Information ----------------------------------
Format Selector................................ 0
Region Name.................................... region10
Revision Level................................. 10
-------------------------------------------------------------------------------
--- Spanning Tree Instance Summary -------------------------------------------
STP Instance
ciated
----------------- -------- --------------- ---------- ---------------
MAIN
mst9
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Description
The name of the existing interface that this route will
use. To display interface names, use the IP LIST INTER-
FACES command.
The number to assign (0 is reserved for the CIST).
Determines the switch's priority for becoming the root
bridge or a designated bridge in the network, with a
lower number indicating a higher priority.
Ranges are:
0..65535 for STP mode
0..65535 in steps of 4096 in RSTP or MSTP modes
MSTID STP State
0 DISABLED
9 DISABLED
Root Port
N/A 1 (2-4094)
N/A None
Introduction
Default Value
N/A
32768
Vlan(s) Asso-
4-99