Set System Userconfig (Sec) - Allied Telesis SwitchBlade x3100 Series Manual

Introduction

SET SYSTEM USERCONFIG (SEC)

Syntax
SET SYSTEM USERCONFIG [ LOGINFAIL=1..10 ] [ LOCKOUTPD=0..30000 ] [
MANPWDFAIL=1..5 ] [ SECUREDELAY={ OFF | 0 | 1..90 } ]
[ MINPWDLEN=1..23 ] [ PERSISTTIMER=1..1440 ]
[ PWDAGEING={ OFF | 0 | 1..365 } ] [ FORCEPWDCHANGE={ YES | NO } ]
Used to modify the global (system-wide) security parameters for user authentication.
Description
Changes to the minimum password length will affect only new users or future updates to
existing user passwords.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
1-48
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Option Description
LOGINFAIL Determines the maximum number of consecutive login
failures allowed before locking out a user or session.
LOCK- Sets the number of seconds to lockout a user or session
OUTPD after the maximum number of consecutive failed login
attempts were made. The maximum number of consec-
utive failed logins is defined by the LOGINFAIL parame-
ter.
SECUREDE- Specifies the number of minutes that a user session can
LAY remain idle before it is automatically timed out.
MANPWD- Not currently supported
FAIL
SECUREDE- Specifies the number of minutes that a user session can
LAY remain idle before it is automatically timed out.
MINP- Specifies the minimum number of characters a user
WDLEN password is allowed to contain. This parameter affects
setting of password in CLEARTEXT format or via the
SET PASSWORD command.
PERSIST- Sets the persistence interval for system counters. The
TIMER value is specified in minute increments.
PWDAGE- Indicates the number of days before a password expires
ING and requires the user to change its password. If the
value is OFF or 0, then the password does not expire.
FORCEP- Indicates if a new user account requires a change in the
WDCHANG password upon the initial login of that user. If the value is
E set to YES, then the user will be prompted for a new
password when they first log in.
Password Recovery
Default Value
5
5
5
6
10
30
NO