Create Psu - Allied Telesis SwitchBlade x3100 Series Manual

Power Management

CREATE PSU

Syntax
CREATE PSU={ A | B | C | D }
Creates the one to four PSUs for the SBx3112
Description
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
PSU
CREATE PSU=A
Example
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Description
The CREATE PSU command allows the user to create
POE Power Supply Units (PSUs) for preprovisioning.
The CREATE PSU command assumes that slot A and B
are for POE type PSUs, and slots C and D are for sys-
tem PSUs.
PSUs are always auto provisioned upon insertion
regardless of system provisioning mode. A single POE
PSU that is not receiving power on the back of the unit
is *not* detected as present in the shelf, because POE
power is used to detect POE presence. If a second POE
PSU is added and powered, then the first will appear as
present.
Introduction
Default Value
1-211