Access Command List - Allied Telesis SwitchBlade x3100 Series Manual

Configuring ACL

6.4.5 Access Command List

Table 6-6 lists the commands that are used for ACL.
TABLE 6-6
Commands
ADD ACCESSLIST INTERFACE
ADD ACCESSLIST RULE
CREATE ACCESSLIST
DELETE ACCESSLIST RULE
DELETE ACCESSLIST INTERFACE
DESTROY ACCESSLIST
RESET ACCESSLIST
SET ACCESSLIST RULE
SHOW ACCESSLIST
Table 6-7 lists the ACL parameters that are used with these commands.
TABLE 6-7
Parameter
accesslistname
RULE
MACDEST
MACSOURCE
PROTOCOL
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Access List Commands
Access List associated command parameters
Description
An arbitrary name. The name of the ACCESSLIST being affected.
The RULE key word indicates the following arguments are to form a single
rule entry on the specified access list. A RULE must be marked with either
the PERMIT or DENY action. PERMIT indicates to allow packets matching
the accompanying match arguments to pass into the Allied Telesis shelf.
DENY prevents matching traffic from entering the shelf.
MAC destination address to match (e.g. 00:0C:25:00:13:8C)
MAC source address to match (e.g. 00:0C:25:00:13:8C)
The value of the Layer 2 protocol field to match. The command will accept
IPV4, IPV6, or a numeric value.
Introduction
6-37