Allied Telesis SwitchBlade x3100 Series Manual page 908

User Event Logging
ENABLE TRACE OUTPUT
Syntax
ENABLE TRACE [ OUTPUT={ CLI } [ FORMAT={ FULL | SUMMARY } ] ]
This allows Event Logs to be stored (in Event Log buffer) and to be displayed to the CLI
Description
(optional). This will also generate an Event Log so that the user can see that logging was
enabled at this point.
This command can be called more that once. For example, the user could input ENABLE
TRACE to turn on tracing, then decide that the CLI needs to be enabled as well and
input ENABLE TRACE OUTPUT CLI.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
ENABLE TRACE OUTPUT CLI
The following output is the result of a DHCP Relay trace:
DHCPRELAY 2010-08-13 12:54:12.044 DST slot(5) 17
Discover Received:
DHCPRELAY 2010-08-13 12:54:12.046 DST slot(5) 18
Discover Forwarded: Instance=MAIN VID=512 ClientInt=11.23 SrcMAC-
Addr=00:02:02:00:AB:97
DHCPRELAY 2010-08-13 12:54:12.749 DST slot(5) 19
Offer Forwarded:
Addr=00:02:02:00:AB:97
DHCPRELAY 2010-08-13 12:54:12.752 DST slot(5) 20
Discover Received:
DHCPRELAY 2010-08-13 12:54:12.754 DST slot(5) 21
Discover Forwarded: Instance=MAIN VID=512 ClientInt=11.23 SrcMAC-
Addr=00:02:02:00:AB:97
DHCPRELAY 2010-08-13 12:54:12.760 DST slot(5) 22
Offer Forwarded:
Addr=00:02:02:00:AB:97
8-36
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
Option Description
OUTPUT CLI
FORMAT FULL
SUMMARY
Instance=MAIN VID=512 Int=11.23 SrcMACAddr=00:02:02:00:AB:97
Instance=MAIN VID=512 ClientInt=11.23 SrcMAC-
Instance=MAIN VID=512 Int=11.23 SrcMACAddr=00:02:02:00:AB:97
Instance=MAIN VID=512 ClientInt=11.23 SrcMAC-
Event Logging TRACE Commands
Default Value