Xe4 Card Attributes - Allied Telesis SwitchBlade x3100 Series Manual

Introduction
TABLE 1-48
Card Attribute
Hardware
Preferred SW Load

1.17.7 XE4 Card Attributes

The only common attribute for XE4 cards is the ADMIN STATE (UP or DOWN).
If the user sets the Administrative State of the NM card to DOWN (using the DISABLE command
Note:
with the FORCE option) and there is only one NM provisioned, upstream data service is lost for the
SBx3112.
Following are the outputs for the Network Interfaces. (For details on the DIRECTION attribute, refer to
E134 - officer SEC>>>> SHOW INTERFACE DIRECTION=NETWORK
--- GE Interfaces ---
Interface State Autonegotiate Flow Control Duplex Speed
----------- ----- ------------- ------------ ------ -------- ---------
3.22 UP-UP On
3.23 UP-UP On
10.16 UP-UP On
10.17 UP-UP On
--- XE Interfaces ---
Interface State Flow Control Direction
----------- ----- ------------ ---------
0.0 UP-UP Off
0.1 UP-DN Off
0.2 UP-DN Off
0.3 UP-DN Off
2.0 UP-DN Off
2.1 UP-DN Off
2.2 UP-DN Off
2.3 UP-DN Off
--- General Interfaces ---
Interface State Name
--------------- ----- ----------
ETH:0 UP-UP MGMT
1-234
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Common Line Card Attributes - Defaults are in Bold) (Continued)
Values / Range
Model Number
Serial Number
CLEI Code
Running
Preferred SW Load
Temporary SW Load
Off
Off
On
On
Network
Network
Network
Network
Network
Network
Network
Network
Description
The TN number for card type
The unique serial number for the card
The CLEI code, if the card has one.
Refer to 1.10.
Direction
Full 1 Gbps Network
Full 1 Gbps Network
Full 1 Gbps Network
Full 1 Gbps Network
XE4 Card Attributes
2.2.)