Add Lldp Interface - Allied Telesis SwitchBlade x3100 Series Manual

Configuring LLDP

ADD LLDP INTERFACE

Syntax
ADD LLDP INTERFACE={ type:id-range | id-range | ifname-list | ALL }
OPTIONS
[ PORTDESC ] [ SYSNAME ] [ SYSDESC ] [ SYSCAP ] [ PORTVLAN ]
[ VLANNAME ] [ PROTOVLAN ] [ PROTOCOL ] [ MACPHYCONFIGSTATUS ]
[ POWERVIAMDI ] [ LINKAGGREGATION ] [ MAXFRAMESIZE ] [ EPSR ]
[ UCP ] [ ALL ]
Adds one or more OPTIONS to the Interface(s) for LLDP. Note that this command does
Description
not enable LDP (that is the SET LLDP INTERFACE MODE command), but adds values for
these optional parameters.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
OPTIONS
Example
ADD LLDP INTERFACE=0.0, 3.22 OPTIONS=EPSR
ADD LLDP INTERFACE 0.0,3.22 OPTIONS=UCP
SHOW LLDP INTERFACE=0.0
--- LLDP Information ---
Interface.......................... 0.0
Mode............................... Off
SNMP Notifications................. Disabled
TLVs Enabled for Transmit.......... UCP
Local Interface Data
Port ID......................... Interface Name:
Port Description................ ETH:0.1
............
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Description
The interface where LLDP is added.
Refer to Table 7-11.
ETH:0.1
Introduction
Default Value
-
7-83