Lldp Command List - Allied Telesis SwitchBlade x3100 Series Manual

Configuring LLDP

7.4.3 LLDP Command List

7.4.3.1 LLDP Protocol Parameters
The following tables list the LLDP protocol procedure configuration options for an LLDP aware NE. They are
divided into two categories:
System wide protocol configuration options that are applicable to the entire NE as a whole.
1.
Protocol configuration options that are applicable on a per network port (interface) basis.
2.
Two parameters (MODE and NOTIFY) are always defined for the interface and have defaults
•
Other parameters (defined as OPTIONS) are optional and are not required.
•
The following tables list and define these parameters.
Table 7-9 lists the parameters that are set system wide and have default values that can be changed or set
•
back to their default values.
Table 7-10 lists the interface parameters that are set for interface(s), and have default values that can be
•
changed.
Table 7-11 lists the optional parameters that define what is to be included in the outgoing LLDPDU.
•
TABLE 7-9
Parameter
TXINTERVAL
TXHOLD
TXDELAY
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
System-Wide Protocol Configuration Options for LLDP
Range Description
5..32768 (30) Determines the protocol transmit periodic timer value and controls
the sending of the LLDP message by the transmitting component for
(in seconds)
the applicable network ports.
2..10 (4) The time-to-live (TTL) value expressed as a multiple of the
TXINTERVAL parameter. The default value is 4 times the TXINTER-
(multiplying factor)
VAL value. The default TTL is therefore 30 x 4 = 120 seconds.
1..8192 (2) Determines the delay in seconds before successive LLDP messages
for a MSAP identifier are transmitted due to a change in value in its
(in seconds)
advertised data. The relationship between the TXDELAY parameter
and the TXINTERVAL parameter is : TXINTERVAL >= (4 * TXDE-
LAY)
Introduction
7-77