Create Egresslimiter Rate Burstsize - Allied Telesis SwitchBlade x3100 Series Manual

Configuring the Egress Port Rate Limiting

CREATE EGRESSLIMITER RATE BURSTSIZE

Syntax
CREATE EGRESSLIMITER=limitername RATE=bits-per-second BURSTSIZE={
4KB | 8KB | 16KB | 32KB | 64KB | 128KB | 256KB | 512KB | 1MB | 2MB
| 4MB | 8MB | 16MB | 32MB | 64MB }
Creates a new EGRESSLIMITER. EGRESSLIMITERs are used to limit the RATE and
Description
BURSTSIZE of traffic transmitted over a particular port or interface. The RATE must be
in 1kb increments and can use K or M, such as "128K" or "3M".
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
EGRESSLIM-
ITER
RATE
BURSTSIZE
Example
CREATE EGRESSLIMITER=sub_gold RATE=1M BURSTSIZE=128KB
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Description
The name of the EGRESSLIMITER that is being added to
the INTERFACE(s).
Specifies the rate to which transmitted traffic must be
limited (in bits per second). The rate may exceed this
value for up to the specified BURSTSIZE for a brief time.
The value must be a non-zero multiple of 8K bits-per-
second. The value may have a suffix of "K" (meaning
times 1,000) or "M" (meaning times 1,000,000).
Specifies the maximum size burst of traffic that is
allowed to exceed the specified RATE. The value is
entered from among an enumerated list of allowable val-
ues.
Introduction
Default Value
6-63