Allied Telesis SwitchBlade x3100 Series Manual page 352

Introduction
enabled for both the system and related ports, or have ensured that all interfaces except the ones
that were in the LAG group have been disabled or disconnected.
The following procedure shows the commands used to destroy the LAG created in the procedure shown in
Figure 4-2.
TABLE 4-4
Step Command
Turn off LAG mode
set lag sfp mode off
1
Verify that LAG mode is off
show lag
2
--- LAG Info Data -------------------------------------------------------
LAG Name
------------------------------- ----------------------------------------------------------
sfp
LAG Name
------------------------------- ----------------------------------------------------------
sfp
Delete all of LAG's member interfaces
delete lag sfp interface 0.8,0.9,3.0
3
Destroy the LAG
destroy lag sfp
4
Verify that LAG has been destroyed
show lag
5
--- LAG Info Data -----------------------------------------------------------------------
LAG Name
------------------------------- ---------------------------------------------------------
LAG Name
------------------------------- ----------------------------------------------------------
4-32
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Configuration Procedure for Destroying a LAG
Provisioned Ports
0.8-0.9, 3.0
Enabled Ports
None
Provisioned Ports
Enabled Ports
Description/Notes
Sets the mode for LAG "sfp" to OFF.
Mode Select Criteria
off portboth & ipboth
& macboth
Speed Oper State
0 Gbps Down
Deletes interfaces 0.8, 0.9 and 3.0 from the
LAG.
Destroys the LAG.
Mode Select Criteria
Speed Oper State
Configuring LAG
Admin Key Index
1 0
Dir Interface ID
Ntwk LAG:0
Admin Key Index
Dir Interface ID