Igmp Trace; Igmp Counters - Allied Telesis SwitchBlade x3100 Series Manual

IGMP Counters

STOP TRACEROUTE
Syntax
STOP TRACEROUTE
Aborts the current TRACEROUTE command that is running on the device.
Description
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
TRACE-
ROUTE
Example
STOP TRACEROUTE

8.6 IGMP Trace

The SBx3112 switch provides the user with the ability to display and view Internet Group Management Protocol
(IGMP) parameters. From the CLI, the user can perform the following functions in real time:
Display reports
•
Display queries
•
Display events (timers, router ports, cleanup, etc.)
•
The user can also configure an output filter on the displays for:
IP address (unicast client or multicast (MCAST) address)
•
MAC address (unicast client or MCAST)
•
Display known MCAST routers
•
Refer to Section 5.1 for more information.
8.6.1 IGMP Counters
The following are examples of IGMP counters for a specific card and interface.
Example output of IGMP counters for a specified card.
•
officer SEC> SHOW IGMP COUNTER CARD 1
--- IGMP Card-Level Message Counters ------------------------------------------
Card Message Type
-------- -------------- -------------- --------------
5 Report
Leave
General Query
OSPF
DVMRP
PIMV1
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
Description
The current TRACEROUTE command that is running
on the device.
Good Count Error Count
230 0
110 15
0 0
0 0
0 0
0 0
IGMP Trace
Default Value
8-25