Show Ip Interface - Allied Telesis SwitchBlade x3100 Series Manual

Configuring the Management Interfaces

SHOW IP INTERFACE

Syntax
SHOW IP [ INTERFACE [ ={ MGMT | type:id-range | ifname-list | ALL }]
[ FULL ] ]
Displays the IP configuration information for the named interface. The information dis-
Description
played includes the interface name, the IP address and the subnet mask, and status. It
shows whether the MGMT or inband ethernet interface has been enabled.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
Example
E135 - >SHOW IP INTERFACE=FULL
--- IP Interfaces ---
Interface.......................... ETH:0 (MGMT)
IP State........................... Disabled
Provisioning
--- IP Interfaces ---
Interface.......................... VLAN:10.0 (inband)
IP State........................... Enabled
Provisioning
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Description
The provisioned IP interfaces
IP Address...................... 10.52.71.108
Subnet Mask..................... 255.255.255.0
Gateway......................... 10.52.71.1
DNS............................. <none>
Domain Name..................... <none>
Card............................ ACTCFC
MGMT............................ Yes
IP Address...................... 10.52.71.108
Subnet Mask..................... 255.255.255.0
Gateway......................... 10.52.71.1
DNS............................. <none>
Domain Name..................... <none>
Card............................ ACTCFC
VLAN ID......................... 10
MGMT............................ Yes
Introduction
Default Value
N/A
1-69