Allied Telesis SwitchBlade x3100 Series Manual page 516

Introduction
ADD HVLAN INTERFACE
Syntax
ADD HVLAN={ hvlanname-list | vid-range } INTERFACE={ type:id-range
| id-range | ifname-list | ALL } [ FRAME={ UNTAGGED | TAGGED } ]
Adds interfaces to the specified layer-2 virtual network. When adding interfaces to an
Description
HVLAN, some restrictions must be considered. Refer to
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
ADD HVLAN=S_300 INTERFACE=0.0,0.1 FRAME=TAGGED
4-196
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Option Description
HVLAN The list of provisioned HVLAN names, separated by a
comma, or the range of VLAN IDs.
INTERFACE The interfaces that are to be added to the HVLAN.
FRAME TAGGED - the frames are transmitted with a VLAN tag.
UNTAGGED - the frame is transmitted without a VLAN
tag.
Configuring VLAN Based HVLAN
4.9.3.2 and 4.9.5.2.
Default Value
N/A
N/A
UNTAGGED