Spanning Tree Command List - Allied Telesis SwitchBlade x3100 Series Manual

Introduction

4.5.12 Spanning Tree Command List

This subsection provides an alphabetical reference for commands used to configure RSTP, STP or MSTP. For
information about spanning trees, including configuration procedures, see 4.5.
TABLE 4-16
4-96
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Spanning Tree Commands
Commands
ADD STP INSTANCE VLAN
ADD TRACE STP
CREATE STP INSTANCE MSTID
DELETE STP INSTANCE VLAN
DELETE TRACE STP
DESTROY STP INSTANCE
DISABLE STP
ENABLE STP
RENAME STP INSTANCE
RESET STP
SET STP
SHOW STP
SHOW TRACE STP
Configuring BPDU Cop