Allied Telesis SwitchBlade x3100 Series Manual page 448

Introduction
TABLE 4-17
Step Command
SHOW the status of the EPSR domain.
officer SEC>> show epsr allied
8
--- EPSR Domain Information ---
EPSR Domain Name...................... allied
EPSR Domain Node Type................. Master
EPSR Domain State..................... IDLE
MAC Address of Master Node............ 00:15:77:F5:68:61
EPSR Domain Status.................... Disabled
Control Vlan.......................... 3501
Enhanced Recovery..................... ON
Primary Interface..................... ETH:[0.2]
Physical State of Primary Interface... DOWN
Primary Interface Type................ DOWNSTREAM
Primary Interface State............... PHYSICALLY FORWARDING
Primary Interface Priority............ 0
Primary Interface Priority Rank....... 0
Secondary Interface................... ETH:[1.3]
Physical State of Secondary Interface. DOWN
Secondary Interface Type.............. DOWNSTREAM
Secondary Interface State............. PHYSICALLY FORWARDING
Secondary Interface Priority.......... 0
Secondary Interface Priority Rank..... 0
Hello Timer (seconds.................. 1
Failover Timer (seconds).............. 2
RingFlap Timer (seconds).............. 0
Hello Time Remaining (seconds)........ 0
Failover Time Remaining (seconds)..... 0
RingFlap Time Remaining (seconds)..... 0
Hello Sequence........................ 0
Data Vlans............................ 3502
4-128
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Configuration Procedure for EPSR - Configure a Master Node
Configuring EPSR
Description/Notes