Allied Telesis SwitchBlade x3100 Series Manual page 514

Introduction
TABLE 4-29
Step Command
Create the standard 802.1q standard VLANs
CREATE VLAN=VIDEO VID=10
2
CREATE VLAN=DATA VID=20
CREATE VLAN=VOICE VID=30
Associate the S_200 and S_300 to ports 0.0/0.1
ADD HVLAN=S_200 INTERFACE=0.0,0.1
3
FRAME=TAGGED
ADD HVLAN=S_300 INTERFACE=0.0,0.1
FRAME=TAGGED
Associate the standard VLAN with the ports 2.2./2.3
ADD VLAN=VIDEO INTERFACE=2.2,2.3
4
Set the NM ports 0.0 and 0.1 to a TPID value (optional)
SET INTERFACE=0.1,0.2 TPID=0x9100
5
Associate the DATA and VOICE VLANs to the VLAN-based HVLAN tunnels.
ADD VLANTUNNELMAP VLAN=DATA
6
HVLAN=S_200
ADD VLANTUNNELMAP VLAN=VOICE
HVLAN=S_300
Destroy the HVLANs
DELETE VLANTUNNELMAP DATA S_200
7
DELETE VLANTUNNELMAP VOICE S_300
DELETE HVLAN=S_200 INTERFACE=0.0,0.1
DELETE HVLAN=S_300 INTERFACE=0.0,0.1
DESTROY HVLAN=S_200,S_300
4-194
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Configuration Procedure for VLAN Based HVLAN
Configuring VLAN Based HVLAN
Description
Creates standard VLANs.
Adds HVLANs to Network interfaces.
Adds standard VLAN (VIDEO) to Customer
interfaces.
Note: This step is needed only when connecting
to a non-Allied Telesis device.
Adds standard VLANs (DATA, VOICE) to HVLAN
tunnels.
Disassociates the DATA and VOICE VLANs from
the VLAN-based HVLAN tunnels.
Removes the Network interfaces 0.0 and 0.1 from
HVLANs S_200 and S_300.
Destroys HVLANs S_200 and S_300.