Set Lldp Interface - Allied Telesis SwitchBlade x3100 Series Manual

Configuring LLDP

SET LLDP INTERFACE

Syntax
SET LLDP INTERFACE={ type:id-range | id-range | ifname-list | ALL }
[ MODE={ TX | RX | BOTH | OFF } ] [ NOTIFY={ ON | OFF } ]
Used to enable or disable LLDP for the interface(s).
Description
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
MODE
NOTIFY
Example
SET LLDP INTERFACE=
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Description
A logical representation of one or more physical ports;
the INTERFACE for which RMON data is enabled
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - used to specify the same historical data collection
parameters on all applicable interfaces in the system
Refer to Table 7-10.
Refer to Table 7-10.
ALL MODE=TX
Introduction
Default Value
OFF
OFF
7-87