Viewing Logs; Controlling Output Of Logs - Allied Telesis SwitchBlade x3100 Series Manual

Introduction
TABLE 1-29
Field
Log Type
Severity
Date and Time

1.11.2 Viewing Logs

Use the command to filter logs immediately in the output, for example to show only logs that have a
SHOW LOG
severity of CRITICAL.

1.11.3 Controlling Output of Logs

To control the output of logs the following are used:
Log Filter - This is a filterid (usually a text string) that is associated with a Category and Severity.
•
Log Output - This is an outputid (also usually a text string) that is associated with the destination for the
•
logs. The destination can be a terminal or SYSLOG server. The outputid can also define the log format.
By combining the two, a filterid can be created and then associated with an outputid.
example configuration.
1-160
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Field Definitions of Management Logs (Continued)
Value Description
INFO Information only
FAULT Fault condition
OTHER All other logs
*C CRITICAL: data service is affected and requires immediate attention.
** MAJOR: data service may be affected and must be investigated.
* MINOR: data service is not affected but could lead to a larger problem.
<blank> NONE: Information only
yyyy-mm-dd Date and time the log was produced
hh:mm:ss
Viewing Logs
Figure 1-8 shows an