Allied Telesis SwitchBlade x3100 Series Manual page 133

CFC Media (SD Card)
PUT FILE
Syntax
PUT FILE={sourcefile|unit:sourcefile} {TFTP SERVER={ipaddress|host-
name} | FTP SERVER={ipaddress|hostname} USER=userid PASSWORD=pass-
word | ZMODEM} [TO=serverpath]
Transfers the specified file from the CFC flash file system or specified SD card to the
Description
given destination. The destination is either an external server, or a card or set of cards in
the shelf. The source file must already exist on the flash file system.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
FILE
TFTP SERVER
ZMODEM
FTP SERVER
USER
PASSWORD
TO
Example
PUT FILE SD5:D104_14.1.0.CFG TFTP SERVER 10.52.65.42 TO LOG-
FILES/D104_14.1.0.CFG
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Description
The file that is either on the CFC FLASH (sourcefile-
name) or on the server that is designated by the path.
The ip address or name of the tftp server.
Specifies the file should be transferred using the ZMO-
DEM protocol.
The ip address or name of the tftp server.
The user id to gain access to the specified server.
The password needed after entering the user id to gain
access to the specified server
The SD card that will receive the file from the specified
server.
Introduction
Default Value
1-103