Using The Ping Command - Allied Telesis SwitchBlade x3100 Series Manual

Configuring the Management Interfaces
TABLE 1-8
Step Action or State
Set system gateway (if not already set)
4
SET SYSTEM GATEWAY 10.51.66.1
Set system DNS (if not already set)
5
SET SYSTEM DNS 10.4.5.7,10.52.7.50
Set system domain name (if not already set)
6
SET SYSTEM DOMAINNAME ALLIED-SYSTEM-1
Enable the interface for the created VLAN (3)
7
ENABLE IP INTERFACE=VLAN:420.0
Show the physical interfaces again.
8
>SHOW IP INTERFACE=ALL
--- IP Interfaces ---
Interface
-------------- ---------- -------- --------------- --------------- ------
ETH:0
VLAN:420.0

1.6.4.2 Using the PING Command

Following is an example output for the PING command
officer SEC>> ping 10.52.66.67
officer SEC>>
PING 10.52.66.67 (10.52.66.67)
64 bytes from 10.52.66.67 (10.52.66.67): icmp_seq=1
--- 10.52.66.67 ping statistics ---
1 packets transmitted, 1 packets received, 0% packet loss
officer SEC>> PING 172.16.66.1
PING 172.16.66.1
officer SEC>>
PING 172.16.66.1 (172.16.66.1)
64 bytes from 172.16.66.1 (172.16.66.1): icmp_seq=1
--- 172.16.66.1 ping statistics ---
1 packets transmitted, 1 packets received, 0% packet loss
officer SEC>> PING 172.16.66.1 FROM INTERFACE=vlan:402.0
PING 172.16.66.1 FROM INTERFACE=vlan:402.0
officer SEC>>
PING 172.16.66.1 (172.16.66.1)
64 bytes from 172.16.66.1 (172.16.66.1): icmp_seq=1
--- 172.16.66.1 ping statistics ---
1 packets transmitted, 1 packets received, 0% packet loss
officer SEC>> PING 172.16.66.1 FROM IPADDRESS=172.16.66.240
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Configure the Inband Interface
Name IP State IP Address
MGMT Disabled 10.52.66.108
inband Enabled
Subnet Mask
255.255.255.0
10.52.66.101 255.255.255.0
Introduction
Details
This step is optional.
This step is optional.
The domain name is a
string of 1 to 63 char-
acters in length.
Card
ACTCFC
ACTCFC
1-59