Allied Telesis SwitchBlade x3100 Series Manual page 556

Introduction
SHOW IGMPSNOOPING
Syntax
SHOW IGMPSNOOPING
[ { STATUS | MCASTGROUPS [ FULL ] | COUNTER
[ { STANDARD | MESSAGERESPONSE | INTERFACE={ type:id-range | id-
range | ifname-list | ALL } |
CARD={ slot-list | ALL } } ] |
INTERFACE={ type:id-range | id-range | ifname-list | ALL }
[ FULL ] |
CARD={ slot-list | ALL } [ FULL ] } ]
The SHOW IGMPSNOOPING command is used to display the current status of the
Description
IGMP snooping feature, the currently configured value of the IP multicast stream count
value, or the set-top box (STB) MAC address(es) that have been configured for a partic-
ular port in the system or for all of the ports in the system.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
STATUS
COUNTER
INTERFACE
CARD
FLOODING
Example
manager SEC>> show igmp INTERFACE eth:11.*
Processing....
--- Interface IGMP Snooping Status/Multicast (MC) Groups ---
Interface Status
-------------- -------- -------------- ------------ ----------- -------------
ETH:11.0 Enabled
ETH:11.1 Enabled
ETH:11.2 Enabled
ETH:11.3 Enabled
5-24
Software Reference for SwitchBlade x3100 Series Switches (Internet Group Management
Protocol (IGMP))
Description
Display the IGMP status information
The type of IGMP snooping counter to show:
CARD -
STANDARD -
MESSAGERESPONSE -
INTERFACE -
The interfaces against which to show IGMP information.
The card against which to show IGMP information.
ALL - All provisioned cards
Provisioned
Snooping Mode MAC Count
Internal
Internal
Internal
Internal
Learned
MAC Count
0 0
0 0
0 0
0 0
Configuring IGMP
Default Value
MC Subscriber
Group Count
0
0
0
0