Allied Telesis SwitchBlade x3100 Series Manual page 844

Introduction
Each bucket will collect 1800 seconds (30 minutes) of data
•
There are 48 buckets, so data older than 24 hours will be discarded.
•
GE1 Port
End of
Interval
Bucket No.
FIGURE 7-15
7.5.8.2 RMON History Configuration Procedure
An RMON configuration procedure to collect historical data involves the following steps:
Create an interface history with an interval and number of buckets.
•
Associate the interface history with a specific interface.
•
Modify the intervals and buckets if needed.
•
To modify the number of buckets, use the SET INTERFACE command. To modify the interval, delete the
•
interface history and add a new interface history.
View the RMON history for an interface with the SHOW command.
•
.
TABLE 7-16
Step Command
Create an interface history and add an interval and number of buckets. Associate a specific interface.
ADD INTERFACE=
1
VAL=interval-list [ BUCKETS=1..2700]
To modify the number of buckets, use the SET INTERFACE command.
SET INTERFACE=<interface ID> COUNTER
2
HISTORY [INTERVAL={interval-
list|ALL}][BUCKETS=<number>]
7-106
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Most Recent Data
1
Data Collection Using Buckets (48) and Intervals (1800 seconds)
Configuration procedure for RMON
COUNTER HISTORY INTER-
Oldest Data
2...47 48
Description
The number of buckets can be 1 to 2700.
Configuring RMON History
Data older
than 24 hours