Allied Telesis SwitchBlade x3100 Series Manual page 463

Release 14.2 - issue 2
Table of Contents

Advertisement

Configuring SuperLoop
TABLE 4-19
Step
Command
show epsr allied-2
17
--- EPSR Domain Information ---
EPSR Domain Name...................... allied-2
EPSR Domain Node Type................. Transit
EPSR Domain State..................... IDLE
MAC Address of Master Node............ 00:00:00:00:00:00
EPSR Domain Status.................... Disabled
Control Vlan.......................... 300
Enhanced Recovery..................... ON
Ring Interface # 1.................... ETH:[9.2]
Physical State of Ring Interface # 1.. UP
Ring Interface # 1 Type............... RING
Ring Interface # 1 State.............. PHYSICALLY FORWARDING
Ring Interface # 1 Priority........... 0
Ring Interface # 1 Priority Rank...... 0
Ring Interface # 2.................... ETH:[3.2]
Physical State of Ring Interface # 2.. UP
Ring Interface # 2 Type............... RING
Ring Interface # 2 State.............. PHYSICALLY FORWARDING
Ring Interface # 2 Priority........... 0
Ring Interface # 2 Priority Rank...... 0
Data Vlans............................ 6, 20
Set the priority for the "common" link (shared by both domains)
SET EPSR=allied-1 INTERFACE=ETH:[3.2]
18
PRIORITY=10
SET EPSR=allied-2 INTERFACE=ETH:[3.2]
19
PRIORITY=11
Enable both EPSR domains
ENABLE EPSR=allied-1,allied-2
20
Review data VLANs per EPSR domain
show epsr datavlans
21
--- EPSR Domain Information ---
EPSR Domain Overlapping Domain(s)/Shrd Ring Port Data Vlans
----------- ------------------------------------ ------------
allied-1
allied-2
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Configuration Procedure for SuperLoop - Peer SuperLoop Domain
allied-2/3.2
allied-1/3.2
Description
Makes the "allied-1" EPSR domain the low-
priority ring (by assigning it a priority of 10).
Makes the "allied-2" EPSR domain the high-
priority ring (by assigning it a higher priority of
11).
Enables the "allied-1" and "allied-2"
EPSR domains on System A.
Note: This enable command must be issued
with both domains specified at the same time.
6,20
6,20
Introduction
4-143

Advertisement

Table of Contents
loading

Table of Contents