Allied Telesis SwitchBlade x3100 Series Manual page 792

Introduction
In this example, the SNMP community is configured as READ only.
TABLE 7-6
Step Command
Show the initial SNMP configuration. The initial status of SNMP is disabled.
SHOW SNMP
1
Use the ENABLE SNMP command so you can create an SNMP community
ENABLE SNMP
2
SHOW SNMP
3
Enable SNMP authentication traps.
ENABLE SNMP AUTHENTICATE_TRAP
4
Create the community, with the community name and the list of trusted trap hosts and management stations.
CREATE SNMP COMMUNITY=public
5
V2CTRAPHOST=172.16.34.2
MANAGER=172.16.32.3 TRAPHOST=
172.16.22.8
Enable the SNMP community, and then enable traps for that community
ENABLE SNMP COMMUNITY=public
6
ENABLE SNMP COMMUNITY=public TRAP
7
Show the SNMP community information.
SHOW SNMP COMMUNITY=public
8
--- SNMP Community Information -----------------
Name.................................. public
-------------------------------------- ---------
Access................................ READ-ONLY
Status................................ ENABLED
Traps................................. ENABLED
Open Access........................... NO
Manager...............................172.16.32.3
TrapHost..............................172.16.22.8
v2cTrapHost...........................172.16.34.2
7-54
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Configuration Procedure for SNMP
Configuring an SNMP Community
Description
Shows that SNMP is disabled.
Enables SNMP for the device.
Shows that SNMP is now enabled.
Captures authentication failure traps.
The SNMP community with the name "public" is
created and the trap hosts are defined.
Enables the SNMP community
Enables traps for the SNMP community.
Displays the SNMP community settings.