Allied Telesis SwitchBlade x3100 Series Manual page 841

Configuring RMON Ethernet Statistics
SET INTERFACE COUNTER
Syntax
SET INTERFACE={ type: | type:id-range | id-range | ifname-list |
ALL } COUNTER { ON | OFF }
The SET INTERFACE COUNTER command enables or disables network monitoring on
Description
an interface or interfaces. The act of enabling monitoring does not affect the administra-
tive state of the interface. This command only affects the state of network monitoring.
Note: If SET INTERFACE COUNTER is used to enable network monitoring while the
interface is disabled, no monitoring will occur until the interface is enabled with the
ENABLE INTERFACE command.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
COUNTER
Example
SET INTERFACE=10.0 COUNTER=ON
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Description
A logical representation of one or more physical ports;
the INTERFACE for which RMON data is enabled
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - used to specify the same historical data collection
parameters on all applicable interfaces in the system
The number of times a counter increments on the inter-
face for a statistic.
ON - enables counter
OFF - disables counter
Introduction
Default Value
7-103