Allied Telesis SwitchBlade x3100 Series Manual page 317

Configuration Guidelines
SHOW POE COUNTER INTERFACE
Syntax
SHOW POE COUNTER INTERFACE [ ={ type:id-range | id-range | ifname-
list | ALL } ]
Shows the counters for the POE interface(s).
Description
PoE counters are fault and status events. These are defined as follows:
•
•
•
•
•
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
Example
officer SEC>> SHOW POE COUNTER INTERFACE=1.0-1.4
--- PoE Interface Counters ---------------------------------------
Interface
-----------
1.0
1.1
1.2
1.3
1.4
Software Reference for SwitchBlade x3100 Series Switches (Power over Ethernet (PoE))
MPS Absent - Maintenance power signature is the signal a PD sends to the switch to
indicate that the PD is connected and requires power; indicates the number of times a
detected PD has no longer requested power from the port
Invalid - indicates a fault with the connected PD
Denied - the number of times PDs requesting power on the port have been denied due
to insufficient power available
Overload - the number of times a connected PD attempted to draw more than 15.4
watts
Short - the number of times the switch provided insufficient current to a connected PD
Description
A logical representation of one or more physical ports
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - all applicable interfaces in the system
MPS Absent
------------ --------- --------- ----------
12
-
6
0
0
Configuring the GE24POE Card
Invalid Denied
0 0
- -
3 3
0 0
0 0
Default Value
Overload Short
--------
0 0
- -
0 0
0 1
0 0
3-15