Allied Telesis SwitchBlade x3100 Series Manual page 216

Introduction
The following table illustrates the display of the MGMT interface LEDs over various states.
TABLE 1-37
MGMT Interface State
UP-UP-Online (1000 LINK)
UP-UP-Online (1000 ACT)
UP-UP-Online (10/100 LINK)
UP-UP-Online (10/100 ACT)
UP-DN-Failed
Disabling of the physical Ethernet layer for the MGMT interface is not supported; however, disable/enable of
the IP service on the interface will affect whether or not the interface is actively passing data (flashing LED).
This is the same behavior as other iMAP products.
The following table illustrates the display of the port activity LEDs on the GE24POE/GE24SFP over various
states:
TABLE 1-38
GE Interface State
UP-UP-Online (1000 LINK)
UP-UP-Online (1000 ACT)
UP-UP-Online (10/100 LINK)
UP-UP-Online (10/100 ACT)
UP-DN-Offline
UP-DN-Failed
The following table illustrates the display of the port LEDs on the XE4 over various states:
TABLE 1-39
XE Interface State
UP-UP-Online (10000 LINK)
UP-UP-Online (10000 ACT)
DN-DN-Offline
UP-DN-Failed
1-186
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
MGMT Interface State and LED State
L/A LED State (on Corresponding CFC200
Solid Green
Flashing Green
Solid Amber
Flashing Amber
Off
GE Interface State and Port Activity LED State on GE Cards
Port Activity LED State (on Corresponding GE24POE/GE24SFP
Solid Green
Flashing Green
Solid Amber
Flashing Amber
Off
Off (Note that since the LED shows link-state, there could be a BFD failure,
where the port may be operationally down but the LED could still be On.
XE Interface State and Port Activity LED State on XE4
Port Activity LED State (on Corresponding XE4
Solid Green
Flashing Green
Off
Off
LED Behavior