Allied Telesis SwitchBlade x3100 Series Manual page 358

Introduction
DESTROY LAG
Syntax
DESTROY LAG=lagname
This command destroys a LAG. The LAG mode must be set to OFF prior to destroying
Description
the LAG. This can be accomplished with the SET LAG command. It is necessary to delete
all interfaces from the LAG prior to destroying it. The member interfaces must be
deleted form the LAG using the DELETE LAG INTERFACE command.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
DESTROY LAG=
4-38
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Option Description
LAG The lagname already created.
card1_card8
Configuring LAG
Default Value