Allied Telesis SwitchBlade x3100 Series Manual page 501

Configuring UCP with ESPR
TABLE 4-24
Step Command
Create the Control VLAN and add it to the appropriate interfaces
CREATE VLAN vid=1200 FORWARDING-
1
MODE=STANDARD
ADD VLAN 1200 INTERFACE 10.1,11.2
FRAME=TAGGED
Create the Data VLAN as a UFO VLAN and give it the attributes to use UCP and PRIMARYUPSTREAM
CREATE VLAN vid=600 FORWARDINGMODE=UPSTREAMONLY
2
ADD VLAN 600 INTERFACE 10.0,10.1,11.2 FRAME=TAGGED
SET VLAN 600 INTERFACE 10.1,11.2
SET VLAN 600 INTERFACE 10.0
Set the GE interfaces as having a direction of NETWORK
SET INTERFACE=10.0,10.1,11.2 GE DIRECTION=NETWORK
3
Configure the node for EPSR.
CREATE EPSR=ALLIED TRANSIT
4
ADD EPSR ALLIED VLAN=1200 TYPE=CONTROL
ADD EPSR ALLIED VLAN=600 TYPE=DATA
Configure the node for RSTP. The path cost for the primary node should be lower than the secondary node.
SET STP PROTOCOL=RSTP FORCE
5
SET STP INSTANCE=MAIN INTERFACE=10.0 PATHCOST=40000
SET STP INSTANCE=MAIN INTERFACE=10.1,11.2 PATHCOST=10
Enable STP
ENABLE STP
6
Using the SET command, you can turn on the Enhanced Recovery feature.
SET EPSR allied ENHANCEDRECOVERY=ON
7
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Configuration Procedure for UCP/EPSR/RSTP
FORWARDING=UCP
FORWARDING=PRIMARYUPSTREAM
Description/Notes
The default for FORWARDINGMODE is
STANDARD, but this is shown here to contrast
this with the Data VLAN
Introduction
4-181