Port Based Hvlan Configuration - Allied Telesis SwitchBlade x3100 Series Manual

Port Based HVLAN Configuration

TABLE 4-26
Field Name
VLAN ID (VID)
The TPID, which is used to identify the frame as a tagged frame in 802.1q, has a value of 0x8100. The TPID value
for the HVLAN (the outer tag), is configurable, and should be set depending on the interconnecting vendor's
recommendation.
To obtain the TPID value that each vendor supports, consult the interconnecting vendor's
Note:
documentation.
4.9.2 Port Based HVLAN Configuration
Figure 4-25 shows a configuration where both 802.1q and HVLANs are created. The 802.1q VLAN (10), is used
for multicasting for video. The HVLAN is provisioned for a business customer who has their own private net-
work and wishes to connect this network to devices on SBx3112 systems. The port-based HVLANs are config-
ured on System A (interfaces 2.0 and 2.1) and on System E (interface 3.0).
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
VLAN Tag Fields (Continued)
Length Description
12 bits The VID identifies which VLAN the frame belongs to, with a range
of 1 to 4094.It consists of the
the Tag Control Information (TCI).
Tag Protocol Identifier (TPID) and
Introduction
4-185