Allied Telesis SwitchBlade x3100 Series Manual page 362

Introduction
SHOW LAG
Syntax
SHOW LAG={ lagname-list | ALL }
[ { INFO | STATE | LACPSTATS | MACSTATS } ]
This command displays information pertaining to Link Aggregation Groups (LAGs) con-
Description
figured on the system. Individual LAGs or a list of LAGs can be displayed by specifying the
valid LAG IDs. If a valid LAG ID is not known, or if information for all LAGs is desired,
use the ALL keyword to display all configured LAGs.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
manager SEC>> SHOW LAG
--- LAG Info Data -----------------------------------------------------------
LAG Name
------------------ ---------------------- ------- ------------ ----- -------
card1tocard8
card8tocard1
4-42
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Option Description
LAG The lag name list, delimited by commas, or ALL
type The type of LAG information displayed can be selected
by using one of the following keywords:
INFO - Displays general LAG information such as inter-
face list, speed, select criteria, and admin key.
STATE - Displays LACP administrative and operational
state information for ports in LAG - Not supported
LACPSTATS - Not supported
MACSTATS - Displays MAC statistics for the LAG, such
as MAC uni/multi/broad-cast packets received/transmit-
ted, and octets received/transmitted counts.
Note that the STATE and LACPSTATS are applicable
only if LAG mode is set to ACTIVE or PASSIVE (indicat-
ing that LACP is configured to run on the system).
Provisioned Ports
1.0-1.1
8.0-8.1
Mode Select
Criteria
off portboth &
ipboth &
macboth
off portboth &
ipboth &
macboth
Configuring LAG
Default Value
ALL
INFO
Admin Index
Key
1 0
2 1