Create Epsr Master | Transit - Allied Telesis SwitchBlade x3100 Series Manual

EPSR and (R)STP Interaction

CREATE EPSR MASTER | TRANSIT

Used to create an EPSR domain. The domain being created is either a 'Transit' or 'Master'
Description
type.
Syntax
CREATE EPSR=epsrdomain { TRANSIT | MASTER [ HELLOTIME=0..65535 ] [
FAILOVERTIME=0..65535 ] [ RINGFLAPTIME=0..65535 ] } [ ENHANCEDRE-
COVERY={ ON | OFF } ]
The following table gives the range of values for each option that can be specified with
Options
this command and a Default Value (if applicable).
Option
EPSR
MASTER | TRANSIT
HELLOTIME
FAILOVERTIME
RINGFLAPTIME
ENHANCEDRE-
COVERY
Example
CREATE EPSR=allied MASTER
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Description
The name(s) that has been given to the EPSR
domain(s)
The type of domain,
If MASTER, then the system is a MASTER node and
the TIME parameters must be specified; otherwise
default values are used.
If TRANSIT, only ENHANCEDRECOVERY can be
specified.
The rate at which the EPSR protocol Health con-
trol message is sent by the master node for this
EPSR domain.
Time for which the master node waits before
declaring that it has detected a break in the ring for
this EPSR domain.
The minimum number of seconds that a master
node must remain in the failed state (before mov-
ing to the complete state), even if the ring has
recovered from its fault condition.
Allows a partial recovery of the ring even if there
are links that are down.
Introduction
Default Value
NA
One from the list
is required
1
2
0
OFF
4-153