Allied Telesis SwitchBlade x3100 Series Manual page 470

Introduction
ADD EPSR INTERFACE
Adds an Interface to the already existing EPSR domain. Only one interface can be speci-
Description
fied at a time when the EPSR domain is of 'Master' node type. If it's a 'Transit' node type
then the user can specify two interfaces at a time. (More than two interfaces are not
allowed in any case.)
Syntax
ADD EPSR=epsrdomain
INTERFACE={ type:id-range | id-range | ifname-list }
[ TYPE={ PRIMARY | SECONDARY } ]
[ PRIORITY=0..127 ]
The following table gives the range of values for each option that can be specified with
Options
this command and a Default Value (if applicable).
Example
ADD EPSR=allied-1 INTERFACE=ETH:[8.2]
4-150
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Option Description
EPSR The domain name of the EPSR.
INTERFACE The Ethernet interface that is being configured as
part of the EPSR.
TYPE For a system that is being designated as the Master
Node, whether the interface will be a PRIMARY
PORT (PP) or Secondary port (SP)
PRIORITY Sets the ring port priority for a domain when the
ring port is part of a common link spanning one or
more superloop segments. Refer to 4.6.10.
EPSR and (R)STP Interaction
Default Value
NA
SECONDARY
0